The Toner Does Not Fix onto the Paper Well
Perform one of the following solutions according to the cause.
<Cause 1> The setting for [Paper Type] is not specified properly.
Solution
|
Specify [Paper Type] properly.
|
<Cause 2> Appropriate paper is not being used.
Solution
|
Replace the paper with that which can be used with this printer.
|
<Cause 3>Depending on the paper type, toner fixation may deteriorate.
Solution 1
|
UFR II Printer Driver
Perform the following procedure in the printer driver.
1.
|
Display the [Quality] sheet.
|
2.
|
Click [Advanced Settings].
|
3.
|
Set [Gray Compensation] to one of the following
Images Only
Text and Images
Graphics and Images
All
|
PCL/PS Printer Driver
See Help of the PCL/PS printer driver.
You can specify the same setting from the printer's control panel.
|
Solution 2
|
Perform the following procedure in the printer driver.
1.
|
Display the [Paper Source] sheet.
|
2.
|
Set [Paper Type] to one of the following settings.
|
|
Currently Selected Setting
|
Setting to be Selected
|
[Plain Paper L2]
|
[Plain Paper L]
|
[Plain Paper L]
|
[Plain Paper]
|
[Plain Paper]
|
[Heavy Paper 1]
|
[Heavy Paper 1]
|
[Heavy Paper 2]
|
[Heavy Paper 2]
|
[Heavy Paper 3]
|
[Envelope]
|
[Envelope H]
|
[Coated Paper 1]
|
[Coated Paper 2]
|
[Coated Paper 2]
|
[Coated Paper 3]
|
[Coated Paper 3]
|
[Coated Paper 4]
|
|
|
When the settings are changed, sometimes residual images appear on non-printed areas.
|
|
Solution 3
|
Perform the following procedure.
1.
|
Press [ ] ( Online).
|
2.
|
Select [Special Print Mode] in [User Maintenance].
|
3.
|
Set [Rough Paper Adj.] to [On].
|
|
<Cause 4> Toner does not fix to the paper in places with high density.
Solution
|
Set [Special Image Mode] to [Level 1].
|
|
If the problem still persists, set it to [Level 2].
|
|
Normally, set [Special Image Mode] to [Off]. Do not set [Level 1] or [Level 2] unless the problems described above occur.
|
|
If it is set to [Level 1] or [Level 2], the print density may be lower than if it was set to [Off].
|
|
<Cause 5> A problem is occurring inside the printer.
Solution
|
If <Ennn-nnnn> appears in the display, follow the procedure in "The Service Call <Ennn-nnnn> Appears in the Display ("n"Represents an Alphanumeric Character)"in " The Message Indicator Is On"to solve the problem.
|