» Maintenance » Cleaning and Maintaining the Printer » Cleaning the Inside of the Printer » Cleaning the Transfer Belt
|
Cleaning the Transfer Belt
If dirt sticks to the transfer belt on the ITB (Intermediate Transfer Belt), this may result in deterioration of print quality. If this happens, clean the transfer belt using the following procedure.
1
Press [  ] (Online).
The Online indicator goes off, allowing you to specify the settings on the control panel.
2
Press [  ] (Settings).
3
Select [User Maintenance] using [ ] and [ ], and then press [OK].
4
Select [ITB Cleaning] using [ ] and [ ], and then press [OK].
5
Select [Yes] using [ ], and then press [OK].
"Cleaning..." is displayed on the display, and transfer belt cleaning begins.
When the message disappears, cleaning is completed.
Cleaning the Intermediate Transfer Belt cannot be canceled. Please wait until it is completed.
NOTE
Cleaning time
It takes approximately 50 seconds.
02K4-021